| Last Modified: 11-29-2007 | 1.6 J | |
| Service Category: Engine/Hybrid System | Section: Cruise Control | |
| Model Year: 2008 | Model: Sequoia | Doc ID: RM000000V1900XX |
| Title: CRUISE CONTROL: DYNAMIC LASER CRUISE CONTROL SYSTEM: DESCRIPTION (2008 Sequoia) | ||
|
Distance Control ECU Power Source Circuit |
DESCRIPTION
This circuit provides power to operate the distance control ECU. The distance control ECU determines information about the vehicle in front based on data from the laser radar sensor, and then decides how much acceleration and/or deceleration is needed to maintain the set distance. The distance control ECU also requests the skid control ECU to apply braking and to sound the buzzer.
WIRING DIAGRAM
INSPECTION PROCEDURE
PROCEDURE
|
1. |
CHECK HARNESS AND CONNECTOR (DISTANCE ECU - POWER SOURCE AND GROUND) |
|
(a) Disconnect the A43 distance control ECU connector. |
(b) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
|
Tester Connection |
Switch Condition |
Specified Condition |
|---|---|---|
|
A43-1 (B) - Body ground |
Ignition switch ON |
11 to 14 V |
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
|
Tester Connection |
Condition |
Specified Condition |
|---|---|---|
|
A43-10 (SGND) - Body ground |
Always |
Below 1 Ω |
|
A43-12 (GND) - Body ground |
Always |
Below 1 Ω |
|
|
|